詳細介紹:自動煎藥機集煎藥包裝一體組合,緊湊合理,美觀大方,節(jié)約空間。常溫常壓,可煎5-8付藥。武火、文火自動轉換 ,高溫時間(≥100℃)自動顯示。筒體采用玻璃,煎藥過程清晰可見。*的液體包裝技術,確保藥液(夏季常溫)存放數日或數月不變質。
包裝機的使用方法請閱讀本公司包裝機說明書,煎藥機的操作方法如下:
1、檢查清洗內部污物、異物等,排盡清洗水。關閉所有閥門。
2、將藥袋放入多孔桶內,適量加水。
3、蓋上鍋蓋,接通電源,打開控制盒上的電源開關,按動模式轉換鈕,進入時間設定狀態(tài),設定煎藥時間,其大小選擇與飲片性質有關,一般飲片中有根、莖、殼、骨等硬物則時間長。然后再按模式轉換鈕,使顯示屏為溫度顯示。
4、按動運行鈕,武火指示燈亮,顯示屏上溫度數值不斷升高,屬于正常;煎藥桶內藥液出現(xiàn)沸騰時,顯示屏顯示100℃,武火指示燈滅,文火指示燈亮,設定的時間開始記時,期間文火、武火指示燈會交替亮滅,屬于正常。(注意:計時時間從100℃開始,如果沸騰時溫度顯示沒有到100℃或以上,則仍不記時。) 5、到設定時間后,自動切斷加熱盤電源,運行指示燈滅,煎藥結束。
6、打開鍋蓋,提起多孔桶,用的U型插件將多孔桶懸空架在桶上,控出藥液,并用附帶的壓盤捶壓藥袋,擠出藥渣中的殘存藥汁,然后,設定包裝包數和包裝量,轉動出液閥門手柄使其*打開,接著啟動包裝機的運行開關,開始包裝,*包有管道內的水,一般不要。
7、藥液包裝完畢后,立即放入一定清水,如果重復處方繼續(xù)煎藥,則重復以上步驟,若不再煎藥,則用水清洗,整理干凈以備后用。
技術參數:
型號 | 容量(ml) | 電壓(V) | 功率(W) | 外形尺寸 | 重量(kg) |
20/1+1 | 20000 | 220 | 1800+560 | 700×560×1100 | 65 |
20/2+1 | 20000×2 | 220 | 1800×2+560 | 1300×650×1250 | 110 |
20/3+1 | 20000×3 | 220 | 1800×3+560 | 1700×650×1250 | 130 |
Introduced in detail: the automatic collection of decocting packaging integrated, compact reasonable, beautiful appearance, space saving. Normal temperature and pressure, can fry 5-8 prescription. High, slow fire automatic conversion, high temperature (≥ 100 ℃) automatic display. Cylinder body made of glass, decocting process clearly visible. Advanced liquid packaging technology, ensure the liquid ( summer temperature ) stored for several days or months.
Packaging machine use please read this company packaging machine instructions, decocting machine operation method is as follows:
1, check and clean the internal dirt, such as foreign bodies, exhaust cleaning water. Close all valves.
In 2, the medicine bag is put into the porous barrel, adding water,
3, cover the pot, the power supply is switched on, open the power switch on the control box, press the mode button, enter the time setting, set the decocting time, its size selection and pieces of nature, general pieces of root, stem, shell, bone and other hard objects is a long time. Then according to the mode switching button, the display to display temperature.
In 4, press the run button, indicator light on the display of force, temperature rising, belongs to the normal; decocting barrel liquid appears to boil, display showed 100℃, fire indication lamp is off, very bright lights, set time to start timing during the slow fire, fire, indicating the exhibit of lanterns turn out bright, belong to the normal. ( Note: the time from 100 ℃boiling temperature display, if not to 100 ℃or above, is not time. ) 5, to set the time, automatically cut off the heating disk power supply, operation indicating light, decocting end.
6, open the lid, mention porous barrel, with a special U type plug porous bucket hanging over the bucket, a liquid medicine and control, with the special plate beating and pressing the medicine bag, extrusion in the medicine residue remaining medicine juice, then, set the package number and packing volume, rotating the valve handle to make it is fully open, then start packing machine operation switch, start packing, the package has a first pipeline in water, generally do not.
In 7, after the liquid packaging, immediay put into a certain water, if repeat prescriptions to decocting, repeat the above steps, if not boiling, water cleaning, clean up for later use.
Technical parameters:
Models of capacity ( ML ) voltage ( V ) power ( W ) dimensions weight ( kg )
20/1+1 20000220 1800+560 700 ×560 ×110065
20/2+1 20000 ×22201800 × 2+560 and 1300× 650× 1250110
20/3+1 20000 ×32201800 × 3+560 and 1700× 650× 1250130